Messages

1

Windows / Re: Cant run 2.3 or 2.4

« on: December 13, 2010, 06:05:49 pm »

Tnks for the quick response, based on the info from the FAQ i think mi OS is the problem...i do have an older version of XP.   

on the ufoconsole.log...
I see the file but when i open it, there is nothing on it, its blank 

The game is installed on C:\UFOAI-2.4-dev, is it ok?

My specs   

------------------
System Information
------------------
   Operating System: Windows XP Professional (5.1, Build 2600) Service Pack 2 (2600.xpsp_sp2_gdr.100216-1441)
          Processor: Intel(R) Celeron(R) CPU 2.53GHz
             Memory: 1024MB RAM
          Page File: 562MB used, 2361MB available
        Windows Dir: C:\WINDOWS
    DirectX Version: DirectX 9.0c (4.09.0000.0904)
DX Setup Parameters: Not found
     DxDiag Version: 5.03.2600.2180 32bit Unicode

---------------
Display Devices
---------------
        Card name: Radeon X1650 Series
     Manufacturer: ATI Technologies Inc.
        Chip type: ATI Radeon Graphics Processor AGP (0x71C6)
         DAC type: Internal DAC(400MHz)
       Device Key: Enum\PCI\VEN_1002&DEV_71C6&SUBSYS_E040174B&REV_00
   Display Memory: 256.0 MB
     Current Mode: 1024 x 768 (32 bit) (60Hz)
      Driver Name: ati2dvag.dll
   Driver Version: 6.14.0010.6925 (English)
      DDI Version: 9 (or higher)
Driver Attributes: Final Retail
 Driver Date/Size: 2/10/2010 20:45:14, 325120 bytes
      WHQL Logo'd: n/a
  WHQL Date Stamp: n/a
         Mini VDD: ati2mtag.sys
    Mini VDD Date: 2/10/2010 23:38:10, 3565056 bytes
        Vendor ID: 0x1002
        Device ID: 0x71C6
        SubSys ID: 0xE040174B
      Revision ID: 0x0000
      Revision ID: 0x0000
      Video Accel:
 Deinterlace Caps: n/a
         Registry: OK
     DDraw Status: Enabled
       D3D Status: Enabled
       AGP Status: Not Available


Any other suggestions??? 

2

Windows / Cant run 2.3 or 2.4

« on: December 13, 2010, 09:33:38 am »

 

I need help!!, for some reason i cant run either version, it crashes at start up, i did see a on the console that says couldn't execute config.cfg on ver 2.3 and 2.4 i uninstalled and installed 2.4 but no log shows up on ufoconsole. and it closes when a new window named SDL_app shows up for only a second

No error messages, nothing.. same issue as in prev posts from win xp SP3, im using SP2...

Did try same troubleshooting steps to no avail...

downloaded and installed ufoai-2.4-dev-1288676501-Debug-7z-small-win32 and ufoai-2.4-dev-Update-1288676501-to-1291398983-Release-7z-small-win32  and for 2.3 was the last bins from Muton..

PLEASEEE HELP!!