Development > Artwork
Models Needed
eleazar:
We already have a stickied list of Needed Models.
If that list is been fulfilled, it should be un-stickied, and this one put in it's place, else the lists should be merged.
Winter:
--- Quote from: eleazar on February 29, 2008, 02:23:18 am ---We already have a stickied list of Needed Models.
If that list is been fulfilled, it should be un-stickied, and this one put in it's place, else the lists should be merged.
--- End quote ---
That would defeat the entire point of why I posted this list, which is to generate some actual interest in creating models. When the ball's rolling I will consider merging the lists.
Zorlen: It's a good start, but these things are meant to be loaded onto supersonic aircraft, so a little more thought to aerodynamics might be a good idea. Also, it would hinge open on the bottom in order to air-drop the UGVs.
Regards,
Winter
eleazar:
--- Quote from: Winter on February 29, 2008, 09:22:56 am ---That would defeat the entire point of why I posted this list.
--- End quote ---
your purpose would also be defeated by potential molders coming to the forum, checking the stickied list, finding the few remaining items of no interest, and leaving, without out having seen this thread further down.
Winter:
--- Quote from: eleazar on February 29, 2008, 05:13:43 pm ---your purpose would also be defeated by potential molders coming to the forum, checking the stickied list, finding the few remaining items of no interest, and leaving, without out having seen this thread further down.
--- End quote ---
That would be a valid point, but common forum practice is to ignore any and all stickies and check the active threads.
Regards,
Winter
Psawhn:
How about doing best of both worlds? Leave the current thread as it is, but add the needed models into the sticky as well. That way, you catch both groups of people. :P
It does mean twice as much work, though, when the hordes of modelers start finishing projects and you need to update the 'completed' status of each one. :)
Edit: On the UGV pods, I always had in mind that they'd land with the aircraft and open up to allow the UGV to drive off. If it's dropped before landing, then there's the possibility of damaging the UGV from the fall or from the dropship landing on it. It also wouldn't need communication gear: the hardpoint would transfer all applicable telemetry to/from the UGV/Pod/Dropship.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version